![]() Product Size: 24.7 * 21 * 5mm (length, width, height), very small size. ![]() Internal thermal protection circuit with hysteresis effect (TSD), without worrying about engine shutdown.It is a powerful H-Bridge that will drive most of your typical DC motor. The L298N H-Bridge Driver is rated up to 2A per channel and a maximum voltage of 46V. This allows the shield to drive two DC motors or one stepper motor. The built-in common-mode transmission will not malfunction when the input pin slide is released. Each CAROBOT Motor and Servo Shield is equipped with an L298N H-Bridge Motor Driver.With this motor driver you can control DC motors. Single operation current 1.5A, peak current 2.5A, low standby current (less than 0.1uA). The L298N Motor Driver Board is built around the L298 dual full-bridge driver, made by STMicroelectronics.The dual H-bridge motor drive can operate two DC motors or a four-wire two-phase step motor.Small size, light weight, zero wait current is the ideal choice for your car model.Built-in low-circuit-resistance MOS switch operation, minimal heat, coolant-free, small size, low power consumption, ideal for pile-running applications.Each can provide 1.5A continuous current, peak current up to 2.5A, thermal protection and can be automatically restored. The supply voltage can be 2V ~ 10V, two DC motors or 4-wire 2-phase stepper motors can be operated, forward or reverse can be reached, it is possible to set the rotation speed. Ideal for motorized drive modules, battery powered smart cars, toy cars, robots.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |